GAS CANISTER SLEEVE
How I make a gas canister sleeveI hope, It is helpful by this flowing steps.Step 1: Make a Pattern for Leather and Cut
Only two types of patterns are needed.One is a donut shape and the other is a rectangle.Step 2: Cut Leather for Upper Parts in a Circle
I used a special tool.Is called a Circle cutter.It doesn't matter if you cut it yourself.Step 3: Edge Creasing on Leather / Prepare for Sewing
I used a divider.Step 4: Punch
I used a divider to adjust the spacing.Important : the number of holes in both patterns should be the same.In my case, there were 45.Step 5: X-stitcing on Leather
One line looked so weak that it sewed two lines at the same time.Step 6: Joining the Top and Side Parts
Put the top and the bottom together.Step 7: Cross Stitch From Beginning to End
Pay attention to the shape and spacing of the stitch.Step 8: Done!
Simple props were created.
十字缝线法